







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Unilock Bathroom Remodeling: The Paradise Owner’s Guide
We install Unilock bathroom remodeling in Paradise at a typical installed cost of $9,000 to $28,000, and we give you the written price before any work starts. If your Unilock vanity, shower surround, or tile system has a failed component, our technicians (up to 21 years of experience) can assess it and quote the fix. Owners usually find out something has gone wrong when a vanity drawer won’t close flush, a shower pan starts holding water, or a tile edge lifts near the floor. The part itself announces the problem before the damage spreads.
Call (866) 977-0526 and a live person answers, day or night. We’re an independent remodeling contractor and not affiliated with Unilock. We install and service Unilock-compatible systems, warranty the work we do, and hand you a written price range up front so you know what you’re spending.
Key Takeaways
- Unilock bathroom remodeling installed in Paradise runs $9,000 to $28,000.
- Most failures start at a single component: a drawer glide, a valve, a shower pan liner, or an edge trim.
- We quote parts and labor in writing before the job starts.
- Our technicians have up to 21 years of experience with cabinet, tile, and shower systems.
- Every repair carries a written guarantee and a free second visit if it fails.
Which Unilock Models This Applies To

Unilock builds several lines of bathroom furniture and surfacing systems, and the right replacement part depends on which one you have. The two families Paradise homeowners call us about most are Unilock’s freestanding and fitted vanity lines (with their reversible drawer fronts and soft-close glides) and its shower and tile systems (pan assemblies, linear drain assemblies, and edge trims).
To identify your part, look for the model label on the inside of a vanity cabinet door or under the sink deck. Unilock prints the series code and dimensions there, and that code tells you which glide, hinge, or drain piece fits. If the label is gone, measure the drawer box height and the glide mounting pattern. Unilock vanity drawer boxes commonly run 15 to 18 inches tall, but the glide pattern is what matters most for a clean swap.
On the OEM-versus-aftermarket question: for structural pieces (shower pan liner, drain body, waterproofing membrane), stay with Unilock or a spec-matched equivalent, because the fit protects your home from water damage. For glides, hinges, and trim, a quality aftermarket part works fine if the measurements match. We don’t claim to stock Unilock parts or carry them on a truck. We source what your model needs and tell you the price before we order.
For cabinetry and surfaces nearby, we also install and service KraftMaid, Cambria, and Silestone, so a single visit can cover the Unilock piece and the parts around it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Unilock Bathroom Remodeling Is Failing
The component usually shows its age before anything breaks. Here’s what Paradise owners tell us they noticed first, and what’s actually going on.
- A drawer that sticks or won’t close flush. The soft-close glide has a worn damper or a stripped screw hole in the cabinet gable. In Paradise’s dry desert air, wood cabinet boxes and drawer boxes move a little with seasonal humidity swings, so the glide takes load it wasn’t meant to carry.
- A shower pan that stays wet or flexes underfoot. The pan liner or the weep holes around the drain have failed, which lets water sit under the pan. If you feel movement when you step, the subfloor or pan assembly is giving way and it needs a look before the leak reaches the room below.
- A tile edge that lifts or chips near the floor. The edge trim (the metal or membrane strip that waterproofs the transition where tile meets floor) has lost its bond, often from movement or moisture wicking into the joint. A loose trim lets water behind the tile.
- Water pooling instead of draining. A linear drain body with a clogged channel or a liner that wasn’t sloped correctly lets water stand. Paradise’s hard water leaves mineral scale that speeds up the clog.
- Peeling caulk or dark stains along the surround joints. That’s usually a sign the waterproofing behind the tile was compromised, not just a caulk problem. Re-caulking over a wet substrate traps moisture and makes it worse.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Unilock bathroom remodeling in Paradise runs $9,000 to $28,000, depending on scope. A single-part repair sits at the low end; a full refresh with vanity, shower, and tile work sits at the high end. Here’s what drives the number.
- Bathroom remodel (full): $9,000 to $28,000, covering vanity, shower or tub, tile, waterproofing, and fixtures.
- Small bathroom remodel: $5,000 to $12,000, for tight layouts and single-surface work.
- Walk-in shower installation: $4,500 to $12,000, including pan, liner, and drain assembly.
- Tub-to-shower conversion: $3,500 to $10,000.
- Shower replacement: $3,000 to $8,500.
- Bathroom vanity installation: $800 to $3,000.
The range moves on part sourcing (OEM versus spec-matched equivalent), whether waterproofing behind the tile has to be rebuilt, and access. We break parts and labor out in the written price so you see what each line costs. Every project carries the 365-Day Done Right Promise: if it’s not done right, we make it right. A repair that fails gets a free second visit.
DIY or Call Us?
Some checks are safe to do yourself. You can open a cabinet and look at a glide for stripped screws, feel a shower pan for flex underfoot, look for water pooling at the drain, and check caulk joints for dark staining. Write down what you find; it helps whoever assesses the job.
Where DIY goes wrong with Unilock systems is waterproofing. Pulling a shower pan, replacing a drain body, or re-setting an edge trim means opening the waterproofing membrane, and a mistake there lets water into the wall and subfloor. That damage shows up months later and costs more than the original repair. Re-caulking a wet joint traps moisture and speeds up the failure. For anything involving the pan, drain, or membrane, call us.
Give us a call and we’ll tell you whether your issue is a quick part swap or a larger fix, with a written price before any tool is picked up. Reach us at (866) 977-0526. Background-checked, uniformed technicians do the work, and you’ll know exactly who’s arriving and when.
FAQs

Pan liners and waterproofing membranes typically last 15 to 25 years if installed correctly, while soft-close glides and hinges usually give out in 5 to 10 years under daily use. Paradise’s dry air and hard water both shorten those numbers: hard water speeds up drain scale, and seasonal humidity swings put extra load on cabinet hardware. Call (866) 977-0526 for an exact quote on a replacement, and estimates are free.
Often yes. Glides, hinges, trim, and caulk joints can be replaced without tearing out the cabinet or shower, and that’s the cheaper fix when the substrate behind them is dry. A flexing pan or a leak behind the tile means the waterproofing has to come out, and that’s a rebuild, not a repair. We tell you which one you’re looking at before any work starts.
A glide or hinge swap is a same-visit job; a vanity installation usually takes half a day to a day; a shower pan or drain replacement runs two to four days once you count waterproofing, curing, and tile. We give you a live arrival time and photo updates before and after, so you’re not waiting on a vague window.
We identify your model from the label or measurements and source the matching part from Unilock or a spec-matched equivalent, depending on which keeps the fit and waterproofing intact. We quote the part and labor in writing before ordering. We’re upfront that we don’t stock Unilock parts and don’t carry them on a truck; we get the right part for your model and tell you the price up front.
Ready to price it? Call Sawyer Remodeling Paradise at (866) 977-0526 for a free estimate. You’ll get a written price before any work starts, a live arrival time, and photo updates before and after. The 365-Day Done Right Promise stands behind the work.
Written by the team at Sawyer Remodeling Paradise, serving Paradise and nearby areas.












